ABB FENA-01, Protocol Manual

Page: 13 / 52

Drive configuration
13
Drive configuration
Overview
This chapter gives information on configuring the FENA-01
Ethernet Adapter module for use with Modbus/TCP.
Ethernet connection configuration
After the FENA-01 Ethernet Adapter module has been
mechanically and electrically installed according to the FENA-01
Hardware Manual, the drive must be prepared for communication
with the module.
The detailed procedure of activating the module for Ethernet
communication with the drive is dependent on the drive type.
Normally, a parameter must be adjusted to activate the
communication (see the drive documentation).
As communication between the drive and the FENA-01 is
established, several configuration parameters are copied to the
drive. These parameters (
Table 1. , Table 2. and Table 3. ) must be
checked first and adjusted where necessary. The alternative
selections for these parameters are discussed in more detail
below the tables.
Note: The new settings take effect only when the module is
powered up the next time or when a ‘Fieldbus Adapter parameter
refresh’ is given (see the drive documentation).