ABB FENA-01, Protocol Manual

Page: 16 / 52

Drive configuration
16
3 COMMRATE
Sets the bit rate for the Ethernet interface.
0 = Auto-negotiate
1 = 100 Mbits/s, full duplex
2 = 100 Mbits/s, half duplex
3 = 10 Mbits/s, full duplex
4 = 10 Mbits/s, half duplex
4 IP CONFIGURATION
Sets the method for configuring the IP address, subnet mask and
gateway address for the module.
0 = Static IP: Configuration will be obtained from configuration
parameters 5-13.
1 = Dynamic IP: Configuration will be obtained via DHCP.
DHCP, Dynamic Host Configuration Protocol, is a protocol for
automating the configuration of IP devices. DHCP can be used to
automatically assign IP addresses and related network
information.
5 IP ADDRESS 1
6 IP ADDRESS 2
7 IP ADDRESS 3
8 IP ADDRESS 4
An IP address is assigned to each IP node on a network. An IP
address is a 32-bit number that is typically represented in “dotted
decimal” notation consisting of four decimal integers, on the range
0..255, separated by periods. Each integer represents the value of
one octet (8-bits) in the IP address. These parameters define the
four octets of the IP address.