![background image](http://html.mh-extra.com/html/abb/dc-machines-dmi/dc-machines-dmi_operating-and-maintenance-instructions-manual_3514032.webp)
Heat exchangers
Figure 19 Mounting of heat exchanger for
DMI 315 and 400.
DMI 315 and 400 prepared for IC 666 and IC
86W heat exchangers are delivered with pre-
mounted gaskets (item 1), set screws (item 2),
washers (item 3 and 4), spacers (item 5 and 6)
and hexagon nuts (item 7) according to figure
19 as standard.
1. Remove nuts and plain washers
(item 5, 6 and 7) from the DMI machine.
2. Heat exchanger spacers must be in position
inside the punched holes at the sealing strip.
3. Remove the covers A (and B if the heat ex-
changer is equipped with it) from the heat
exchanger.
4. Place the heat exchanger on top of the DMI
machine and joint the heat exchanger at the
flat point set screws of the DMI machine
(item 2).
5. Tighten the heat exchanger with the plain
washers and nuts (item 5, 6 and 7).
6. Assemble the covers A (and B if the heat
exchanger is equipped with it) on the heat
exchanger.
Note!
Do not lift the motor and heat exchanger by the
heat exchanger’s lifting eyes