AP200 series
Rugged pH/Redox (ORP) sensor systems with rapid temperature response for critical processes
2 Mechanical Installation
10
IM/AP200 Rev. S
2.5 Jetwash System Assembly
The system is supplied with a blanking plug fitted to the jetwash
tubing connector. If the jetwash system is to be used, remove
the plug and fit the jetwash supply tube as shown in Fig. 2.9.
Note.
Recommended
tubing
is
6mm
OD
semi-rigid
polyethylene tube (part no. 0212035).
Fig. 2.9 Fitting Jetwash Supply Tubing
1
2
3
4
Remove jetwash port sealing
nut and retain for further use
(See
Note
below)
Slide connector
onto tubing
Slide ferrule onto tubing
Push tubing onto jetwash
port, screw connector onto
jetwash port and tighten to
recommended torque of
60cNm
Note.
The seal nut must be fitted when
the jetwash tubing is not being used.
