Manual for High Voltage Process Performance Motors
Transport and Unpacking - 13
3BFP 000 063 R0101 REV D
2.5.3 Rolling bearings
Apply the following measures:
•
Rolling bearings should be well lubricated during storage. Acceptable grease types are
presented in Chapter 2.1.2 Bearing plate
•
Turn the rotor 10 revolutions every three months to keep the bearings in good condition.
Remove any possible transport locking device during turning the rotor
•
Machines may be provided with a locking device to protect the bearings against damage
during transport and storage. Check the bearing locking device periodically. Tighten the
transport locking device according to the axially locating bearing type, see Table 2-1
Tightening torque for horizontal machines (lubricated screw).
NOTE: A too high tightening torque on the transport locking device will damage the bearing.
NOTE: The type of bearings used are found on the bearing plate, see Chapter 2.1.2 Bearing
plate, and axially locating bearing information from the dimension drawing.
Table 2-1. Tightening torque for horizontal machines (lubricated screw)
Axially locating bearing
type
Tightening torque [Nm]
Tightening torque
[pound foot]
6316
45
33
6317
50
37
6319
60
44
6322
120
90
6324
140
100
6326
160
120
6330
240
180
6334
300
220
6034
140
100
6038
160
120
6044
230
170
