ABB ACS880-x04, Firmware Manual

Page: 265 / 604

Parameters 265
30.12 Maximum speed Defines the maximum allowed speed.
WARNING! This value must not be lower than 30.11
Minimum speed .
WARNING! In frequency control mode, this limit is not
effective. Make sure the frequency limits ( 30.13 and
30.14 ) are set appropriately if frequency control is
used.
WARNING! In a master/follower configuration, do not
set maximum and minimum speed limits with the same
sign on a follower drive. See section
Master/follower
functionality (page 31 ).
1500.00 rpm;
1800.00 rpm
(
95.20 b0)
-30000.00 …
30000.00 rpm Maximum speed. See par.
46.01
30.13 Minimum frequency Defines the minimum allowed frequency.
WARNING! This value must not be higher than 30.14
Maximum frequency .
WARNING! This limit is effective in frequency control
mode only.
-50.00 Hz;
-60.00 Hz
(
95.20 b0)
-500.00 … 500.00
Hz Minimum frequency. See par.
46.02
30.14 Maximum
frequency Defines the maximum allowed frequency.
WARNING! This value must not be lower than 30.13
Minimum frequency .
WARNING! This limit is effective in frequency control
mode only.
50.00 Hz;
60.00 Hz
(
95.20 b0)
-500.00 … 500.00
Hz Maximum frequency. See par.
46.02
30.15 Maximum start
current enable A temporary motor current limit specifically for starting can be
defined by this parameter and
30.16 Maximum start current .
When this parameter is set to Enable , the drive observes the
start current limit defined by 30.16 Maximum start current . The
limit is in force for 2 seconds after initial magnetization (of an
asynchronous induction motor) or autophasing (of a
permanent magnet motor), but not more often than once in
every 7 seconds. Otherwise, the limit defined by
30.17
Maximum current is in force.
Note: The availability of a start current higher than the general
limit depends on drive hardware. See the rating data in the
hardware manual of the drive.
Disable
Disable Start current limit disabled. 0
Enable Start current limit enabled. 1
30.16 Maximum start
current Defines a maximum start current when enabled by parameter
30.15 Maximum start current enable .
-
0.00 … 30000.00 A Maximum start current. 1 = 1 A
30.17 Maximum current Defines the maximum allowed motor current. 0.00 A
0.00 … 30000.00 A Maximum motor current. 1 = 1 A
No. Name/Value Description Def / FbEq16