ABB ACS880-204LC, Hardware Manual

Page: 14 / 278

The manual is written for readers worldwide. Both SI and imperial units are shown.
Categorization by frame size and option code
The instructions and technical data which concern only certain module or frame sizes are
marked with a size identifier.
The module size can be identified from the basic code visible on the type designation label,
for example, “ACS880-204LC-0400A-7”, where 0400A is the module size. The option codes
of the module are listed after a plus sign. Chapter Ordering information, section Frame R8i
and multiples explains the type designation code in detail.
The frame size of the module can be, for example, R8i or 2×R8i, the latter representing a
supply unit consisting of two parallel-connected R8i supply modules. The table under section
Ratings lists the units and frame sizes.
Use of component designations
Some device names in the manual include the item designation in brackets, for example
[Q20], to make it possible to identify the components in the circuit diagrams of the drive.
Terms and abbreviations
Description Term
Assistant control panel ACS-AP-x
Auxiliary measurement unit BAMU
Type of control board BCON
Type of control unit BCU
Internal power supply board in frame R8i modules BDPS
I/O module for controlling cabinet fans CIO
Circuit board in which the control program runs Control board
Control board built in a housing (often rail-mountable) Control unit
One section of a cabinet-installed drive. A cubicle is typically behind a door of its own. Cubicle
DC circuit between rectifier and inverter DC link
Distributed drives communication system protocol DDCS
Digital input DI
Frequency converter for controlling AC motors Drive
Electromagnetic compatibility EMC
Electromagnetic interference EMI
Physical size of the drive or power module Frame, frame size
Incoming unit ICU
Insulated gate bipolar transistor IGBT
IGBT bridge and related components enclosed inside a metal frame or enclosure.
Intended for cabinet installation. IGBT supply module
IGBT supply module(s) under control of one control board, and related components. IGBT supply unit
Part of the cabinet line-up that contains the input power cable terminals. Can also
contain switching equipment etc. Incoming unit
DC circuit between rectifier and inverter Intermediate circuit
Inverter unit INU
Inverter bridge, related components and drive DC link capacitors enclosed in a metal
frame or enclosure. Intended for cabinet installation. Inverter module
IGBT supply unit ISU
Inductor-capacitor-inductor filter LCL filter
14 Introduction to the manual