ABB ACS580 Series, Hardware Manual

Page: 143 / 468

7. Connect the motor cable:
•
Ground the shield 360 degrees by tightening the clamp of the power cable
grounding shelf onto the stripped part of the cable (7a).
IP66 (UL Type 4X): for best EMC performance, do not ground the shield.
The motor cable shield should only be grounded at the motor end, not at
the drive end.
• If you need more working space, open the screw (7d) and lift the EMC plate
off. Remember to put it back after you have installed motor and input
power cables.
• Connect the twisted shield of the cable to the grounding terminal (7b).
• Connect the phase conductors of the cable to the T1/U, T2/V and T3/W
terminals. Tighten the screws to the torque given in the table below (7c).
R3 R1…R2
BRAKE RES INPUT
PE
MOTOR
R-
R+
UDC+
W / 3 T V / 2 T U / 1 T 3 L 2 L 1 L
7b 7c
7a
MOTOR
T1/U T2/V T3/W
INPUT
L1 L2 L3
BRAKE RES
R-
R+
UDC+
PE
7b
7c
7a
R4 R4 v2
7c
7b
7a
L1 L2 L3
R+
UDC+ R-
T1/U T2/V T3/W
7a
7c
7b
7d
L1 L2 L3
R+
UDC+
R- T1/U T2/V T3/W
R4 v2 R4 R3 R2 R1 Frame size
lbf·ft N·m lbf·ft N·m lbf·ft N·m lbf·ft N·m lbf·ft N·m
4.0 5.5 3.0 4.0 2.6 3.5 1.1 1.5 0.7 1.0 T1/U, T2/V, T3/W
2.1 2.9 2.1 2.9 1.1 1.5 1.1 1.5 1.1 1.5
PE,
0.9 1.2 0.9 1.2 0.9 1.2 0.9 1.2 0.9 1.2
Electrical installation – Global (IEC) 143