ABB ACS580-04, Quick Installation Manual, Page: 4 / 100

4 EN – Quick installation guide
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
5. Measure that the installation is de-energized.
•
Use a multimeter with an impedance of at least 1 Mohm.
•
Make sure that the voltage between the drive module input power terminals
(L1/U1, L2/V1, L3/W1) and the grounding (PE) busbar is close to 0 V.
•
Make sure that the voltage between the drive module UDC+ and UDC- terminals
and the grounding (PE) busbar is close to 0 V.
6. Install temporary grounding as required by the local regulations.
7. Ask for a permit to work from the person in control of the electrical installation work.
Select the power cables
Size the power cables according to local regulations to carry the nominal current given on
the type designation label of your drive.
Ensure the cooling
See table G on page 96 for the losses and the cooling air flow through the drive. The
allowed operating temperature range of the drive without derating is -15 to +40 °C.
Protect the drive and input power cables
See table G on page 96 .
Install the drive module into a cabinet
See figure B on page 95 :
•
Install the punched section to the back of the cabinet frame.
•
Remove the pedestal guide plate from the bottom of the drive module.
•
Install the support rails and pedestal guide plate to the cabinet bottom frame.
•
Install the telescopic insertion ramp to the pedestal guide plate.
For B051: See figure C on page 95 :
•
Remove the sheeting from the clear plastic shrouds from both sides.
See figure D on page 95 :
•
Install the mounting bracket to the drive module.
•
For B051:
•
Install the bottom grille to the drive module if there is no bottom plate in the cabinet
and degree of protection of IP20 is needed for the drive module from the bottom
side.
•
Install the top metallic shroud to the drive module.
•
Install the back shrouds to the drive module.
See figure E on page 95 :
•
Attach the drive module to the cabinet frame with chains.
•
Push the drive module into the cabinet along the telescopic insertion ramp.
•
Remove the ramp.
See figure F on page 95 :
•
Attach the drive module to the pedestal guide plate.
•
Attach the drive module from top to the punched section at the cabinet back. Note :
The mounting bracket grounds the drive module to the cabinet frame.