ABB ACS-AP Series, User Manual

Page: 46 / 60

46 Fault tracing
Faults
Faults are problems that require your attention before you can start the drive again.
Take the following steps to solve the fault situation:
1. Identify and eliminate the cause of the fault. In the
Fault view, you can see the
fault code. Refer to the relevant firmware manual for more information on the
fault.
2. Reset the fault by pressing ( Reset ) in the Fault view.
In the Fault view, the keys have the following functions:
• Press ( Hide ) or any of the arrow keys to temporarily hide the fault and go
back to the previous view. If there is also an active warning, it is displayed instead.
The fault view reappears after 60 seconds if no keys have been pressed.
• Press ( Reset ) to reset the fault and return to the previous view.
• Press the key to open the context-sensitive help. The help page has a shortcut
to the Fault Diagnostics Assistant which helps you solve the fault situation.
Display LED Type
blinking green See Warnings (below).
continuous green The connection between the control panel
and the drive is faulty.
Check that the connection cable is properly
attached.
continuous green The control panel type is not compatible with
the drive you attempt to use it with.
See
Compatibility on page 9 .
continuous green The connection between the control panel
and the drive has been lost.
Check the control panel network
connections.
Select another drive.
?
Assistant Panel Guide Rev B.book Page 46 Tuesday, April 10, 2012 12:08 PM