ABB ACS 800 Series, Firmware Manual

Page: 160 / 340

Actual signals and parameters
160
10.16 ZERO POS PTR Defines the source or constant for Zero position input. Checks for this signal
before the drive can be started in case the drive has stopped in a fast stop or
fault condition.
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value. See parameter 10.04 EXT1 STRT PTR
for information on the difference.
-
10.17 SYNC PTR Defines the source or constant for value Par. 10.17 SYNC PTR of parameter
10.14 SYNC SEL.
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value:
- Parameter pointer: Inversion, group, index and bit fields. The bit number is
effective only for blocks handling boolean inputs.
- Constant value: Inversion and constant fields. Inversion field must have value
C to enable the constant setting. -
10.19 SLOW DOWN PTR Defines the source or constant for value Par. 10.19 SLOW DOWN PTR of
parameter 10.09 SLOW DOWN INPUT .
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value. See parameter 10.04 for information on
the difference.
-
10.20 EXT SPD LIM PTR Defines the source or constant for the External Speed Limit command. The
command can be a normally open (if the bit selection is not inverted) or
normally closed (if the bit selection is inverted) logic according to the selection
in the pointer value. When the command is active, the drive speed reference is
limited to the value defined in Par.
20.22 MAX EXT LIM SPD or Par. 20.23 MIN
EXT LIM SPD depending on the motor direction.
Note: For safety, it is better to use the bit selection as normally closed by
inverting the bit in the pointer value.
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value. See parameter 10.04 EXT1 STRT PTR
for information on the difference.
-
10.21 HOMING SEL PTR Defines the source or constant for Homing activation command. When the
command is activated, homing sequence is activated and homing reference
(Par.
11.14 ) is used as the speed reference.
Note: Homing is activated only when the drive is controlled from EXT1.
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value. See parameter 10.04 EXT1 STRT PTR
for information on the difference.
-
10.22 HOMING ACK PTR Defines the source or constant for Homing acknowledge command. When the
command is activated and the drive is in homing sequence, the drive actual
position (
02.21 ) is initialized with the value set in parameter 78.10 HOME
POSITION. The drive stops automatically on receiving this command during
the homing sequence.
Note: Homing is activated only when the drive is controlled from EXT1.
-255.255.31 …
+255.255.31 / C.-
32768 … C.32767 Parameter index or a constant value. See parameter 10.04 EXT1 STRT PTR
for information on the difference.
-
Index Name/Selection Description FbEq