ABB ACH-AP-H, User Manual

Page: 65 / 82

Faults
Faults are problems that require your attention before you start the drive again.
Refer the following steps to solve the fault situation:
1. Identify and eliminate the cause of the fault. In the Fault view, you can see the fault
code. Refer to the relevant firmware manual for more information on the fault.
2.
Reset the fault by pressing ( Reset ) in the Fault view.
In the Fault view, the keys have the following functions:
•
Press ( Hide ) or any of the arrow keys to temporarily hide the fault and go back to
the previous view. If there is also an active warning, it is displayed instead.
The fault view reappears after 60 seconds if no keys have been pressed.
•
Press ( Reset ) to reset the fault and return to the previous view.
•
Press the (
?
) key to open the context-sensitive help. The help page has a shortcut to
the Fault Diagnostics Assistant which helps you solve the fault situation.
Warnings
Warnings mean that a possible problem has been detected and may need attention, and
the drive can still run. A warning message disappears once the condition that triggered it
goes away.
•
Press ( Hide ) to hide the warning message and go back to the previous view.
If the warning is still active after 60 seconds of no key presses, the Warning view
reappears automatically.
•
Press the (
?
) key to open the context-sensitive help.
Note: If multiple warnings are active, the total number of active warnings is displayed.
Use and to scroll through the warnings.
Fault tracing 65