40
POLE HEDGE TRIMMER
The blades move slowly, making noise and the blades heat up
The blades are dry
Oil the blades
The blades are bent
Contact our customer service center
Cutting tooth damaged
Contact our customer service center
The blades too tight or loose
Tighten the nuts
The extension cord wire size is
inadequate
Use an extension cord with the necessary
wire size. Refer to the wire size table in the
Safety section.
Engine stops
Cutting device is blocked
Remove blockage
Excessive vibration/noise or exhaust
Cutting device is dull/damaged
Replace with a new one
Bolts/nuts are loosen
Tighten bolts/nuts
Unsatisfactory cutting performance
Cutting blade is dull/damaged
Have a specialist to sharpen or replace it
Cutting material exceeds capacity
Only cut materials acc. to the capacity of
the product.
*If further assistance is required, contact our customer service center.
