19
3. Check the chain tension using one
hand to lift the saw chain against the
weight of the product. The correct
chain tension is achieved when the
saw chain can be lifted by approx. 2-
4mm(0.94inch) from the guide bar in
the centre.
a. In example (A) the chain is too tense.
b. In example (B) the chain is not tense
enough.
4. Hold the guide bar tip up and move
the saw chain back and forth along the
guide bar. Make sure the saw chain
moves freely and is in proper mesh
with the sprocket. If the saw chain
does not move easily, slowly turn the
chain-tensioning screw
counterclockwise to loosen the saw
chain.
5. Hold the guide bar tip up and
securely tighten the bar-retaining nut.
Do not tense the chain too much.
Connecting To Power Supply
WARNING:
Make sure the
trigger switch is released before
connecting or disconnecting the power
source. Refer to the “Starting and
Stopping” section.
The cable section must be at least
1.5mm2 and the cable must have a
maximum length of 25m(82ft) and it
must be completely unrolled before
starting to work with the product
Insert the extension power cord to the
hole and on the hook provided to this
effect at the back of the product.
Prolongators longer than 25m(82ft) will
reduce the working efficiency of the
product.
Adding Sawchain Oil
This unit comes from the factory with
the chain oil tank empty. Fill the chain
oil tank with good quality sawchain oil
before starting or using the unit.
