AAT MEGA II CLEANER, Operating Manual

Page: 77 / 92

Mega II Operating Manual Rev. 2.0 10/15/2005 69
B.6.2 CHANGE CYCLE SETUP 1-5
This selection allows the user to enter settings of the various modes of the
Ultrasonics cycle. i.e. setpoint and time values. All cycle setups have pre-
defined values entered for functional testing at the factory. This manual
provides guidelines for setting up the cycle, but testing should be performed to
verify the cleaning performance.
Key Press sequence to change cycle setup:
Note: See
Table 6. Cycle Change Key Press Sequence
for the next sequence in the change
cycle setup.
Key Selection OP Display
From Main Menu, select Change Cycle Setup 1-5
Select/Arrow/Clear
Press “
SELECT
” Key
or use arrow keys to
select cycles 2-5
Change Cycle #1
Select/Arrow/Clear
Press “
ENTER
” Key
and wait 2-3 sec.
Ultrasonic Enable = ___
New Settings (0,1) = ___
Range 0-1
0= Disable
1= Enable
Arrow keys to adjust
(If 0 is selected, time setting is
bypassed.)
Ultrasonic Mode = _ _ _._ s
New Setting = _ _ _. _s
Range 0-999.9
Arrow keys to adjust
Prewash Enable =____
New Settings (0,1) =____