Venture 3-Line Telephone with Answering Device User Guide 15
Getting star
ted
Checking the
installation
Single phone check
To check the installation of a single
Venture TAD, simply press each line
key. You should hear a dial tone and
each line’s indicator should light.
System check
Once each Venture set is installed,
you need to ensure that your system
is communicating. To do so, you
must verify that line 1 is common to
each Venture set in your system.
To verify, first lift the handset and
press the line 1 key on ONE set. You
should hear a dial tone and the line 1
indicator should be lit—leave the
handset off hook. Next, move to each
Venture set in the system. If the line
1 indicator light is lit on all sets, you
have successfully installed your
Venture system!
You can also press
J
and
enter 00 using the dial pad—all
phones in your system should ring.
At each phone, check the following:
1.
When idle, press
’
to review
the ID and name of each phone
in your system. If you have
assigned phone 01 the name
“Venture One” and it is not in
use, the display shows:
Venture One
Phone 01 idle
If “Venture One” is being used,
the word
idle
is replaced by
busy
. If neither idle nor busy
shows, see “Communication
problems” on page 63.
2.
Repeat for each phone in the
system.
3.
Reconnect any non-Venture
equipment that shares the
telephone lines used by your
Venture phones. (This
equipment was disconnected
before the installation of your
Venture phones.)
P0814619 01 E UG.VTAD Page 15 Wednesday, April 15, 1998 4:30 PM