4
4. Wiring the C220 Controller
The Trident Remote Control System is supplied with a wiring harness that is
appropriate for the system option. The harness has a 30-way rectangular connector which
mates with the C220 Controller, and, depending on the system option, a blunt-cut cable or
connectors which mate to existing connectors in the truck. The main power (+12 volt,
red) wire must be fused externally to a maximum of 12 ampères for either harness. The
main ground (black) wire must be connected to the vehicle’s battery negative circuit or to
a solid vehicle ground (positive-ground systems are
not
supported). The LOOP OUT is a
safety circuit and
must
be used to enable (usually by closing a normally-open hydraulic
dump valve) machine functions which have the potential to cause damage or injury.
