162016
(picture 15)
ROLLING JACK INSTALLATION
-adjust the distance of the rolling jack, put the rolling jack between the slide track.
-adjust the sub beam to make sure the sliding of the rolling jack.
LINE CONNECTION
Connect the electrical and oil line according to the electric wiring diagram and oil line
connection
To avoid the unexpected lift closure due to mechanical safety device
release insert wooden pieces in the inner part of the base frame.
Pay attention not to work under the lift until the hydraulic system has
not been completely filled with hydraulic oil.
To insert the lift into the recess, sling the lift as described and pay
attention not to damage the hoses and electrical cables.
Before placing the pneumatic and hydraulic hoses to the control unit,
stick adhesive tape on the pipe fittings in order to protect the hoses
from dust and impurities which could damage the hydraulic system.
Perform electric, hydraulic and pneumatic connections, follow carefully the
relevant numbering. Regarding the proper connections necessary to make
the car lift perfectly working.
Chapter 4 INSTALLAION
Skilled personnel only is allowed to perform the operations shown below.
-open the control box front cover
-connection of power supply: the connection wires (BVR-3*2.5mm
2
+1*1.5mm
2
) for
power supply are connected to terminalsL1#, L2#, L3#, the zero wire is connected
to terminal 0#. The ground wire is connected under the bolt marked ground.
-the electric panel are arranged by the manufacturer for operating at 400V
three-phase, therefore if you wish the lift to operated at 230V three-phase, change
the connection on the transformer and motor.
Summary of Contents for AutoLift AL-162016
Page 25: ...162016 Chapter 8 APPENDIX ...
Page 26: ...162016 Chapter 9 APPENDIX ...
