162016
(picture 13)
RISK OF ELECTRIC SHODK
Risk of electric shock in areas of the lift housing electrical wiring.
Do not use jets of water, steam solvents or paint next to the lift, and take
special care to keep such substances clear of the electrical control panel.
RISKS RELATED TO IMAPPROPRIATE LIGHTING
The operator and the maintenance fitter must be able to assure that all the
areas of the lift are properly and uniformly illuminate compliance with the
laws in force in the place of installation.
RISK OF COMPONENT FAILURE DURING OPERATION
The manufacturer has used appropriate materials and construction techniques
in relation to the specified use of the machine in order to manufacture a reliable
and safe lift. Note however, that the lift must be used in conformity with
manufacturer’s prescriptions, and the frequency of inspections and
maintenance works recommended .
RISK RELATED TO IMPROPER USE
Persons are not permitted to stand or sit on the platforms during the lift
manoeuvre or when the vehicle is already lifted.
The handling of safety devices is strictly forbidden.
Never exceed the maximum carrying capacity of the lift, make sure the
vehicles to be lifted have no load.
It is therefore essential to adhere scrupulously to all regulations regarding
use, maintenance and safety contained in this manual.
Chapter 4 INSTALLAION
Skilled and authorized personnel only should be allowed to perform
these operations, follow all instructions shown below carefully, in
order to prevent possible damage to the car lift or risk of injury to
people. Be sure that the operating area is cleared of people.
Skilled technicians only, appointed by the same manufacturer or by
authorized dealers, are allowed to install the car lift. Serious damage to
people and equipment can be caused if this rule is not followed.
INSTALLATION REQUIREMENTS
The car lift must be installed according to the specified safety distances from walls
must be 1000 mm at least, taking into consideration the necessary space to work
easily. Further space for the control site and for possible runways in case of
Summary of Contents for AutoLift AL-162016
Page 25: ...162016 Chapter 8 APPENDIX ...
Page 26: ...162016 Chapter 9 APPENDIX ...
