2
Installation, Operation and Parts Manual
AutoLift AL-6254
1.1
Important notices
IMPORTANT SAFETY INSTRUCTIONS
Advance AutoQuip will offer one‐year's quality warranty for the whole machine
，
during which any quality problem will be properly
solved to the user's satisfaction. However, we will not take any responsibility for whatever bad consequence resulted from improper
installation and operation, overload running or unqualified ground condition.
This 2‐posts hoist is specially designed for lifting motor vehicles that weighs within its outmost lifting capacity. Users are not allowed to
use it for any other purposes. Otherwise, we, as well as our sales agency, will not bear any responsibility for accidents or damages of the
hoist. Make sure to pay careful attention to the label of the lifting capacity attached on the hoist and never try to lift cars with its weight
beyond.
Read this manual carefully before operating the machine so as to avoid economic loss or personnel casualty incurred by wrong operation.
Without our professional advice, users are not permitted to make any modification to the control unit or whatever mechanical unit.
1.2
Qualified personnel
1.2.1
Only these qualified staff, who have been properly trained, can operate the hoist.
1.2.2
Electrical connection must be done by a competent electric i a n .
1.2.3
People who are not concerned are not allowed in the lifting area.
1.3
Danger notices
1.3.1
Do not install the hoist on any asphalt surface.
1.3.2
Read and understand all safety warnings before operating the hoist.
1.3.3
The hoist, if is not specially designed upon customer’s request, is not fit for outdoor use.
1.3.4
Keep hands and feet away from any moving parts. Keep feet clear of the hoist when lowering.
1.3.5
Only these qualified people, who have been properly trained, can operate the hoist.
1.3.6
Do not wear unfit clothes such as large clothes with flounces, tires, etc, which could be caught by moving parts of the hoist.
1.3.7
To prevent evitable incidents, surrounding areas of the hoist must be tidy and with nothing unconcerned.
1.3.8
The hoist is simply designed to lift the entire body of vehicles, with its maximum weight within the lifting capacity.
1.3.9
Always insure the safety latches are engaged before any attempt to work near or under the vehicle.
1.3.10
Make sure to place the lifting pads to the positions as suggested by vehicle makers and when gradually lift the vehicle to the
desired height, operators should be certain that the vehicle will not slant, roll‐over o
r
slide in lifting process.
1.3.11
Check at any time the parts of the hoist to ensure the agility of moving parts and the performance of synchronization. Ensure
regular maintenance and if anything abnormal occurs, stop using the hoist immediately and contact our dealers for help.
1.3.12
Lower the hoist to its lowest position and do remember to cut off the power source when service finishes.
1.3.13
Do not modify any parts of the hoist without manufacturer’s advice.
1.3.14
If the hoist is going to be left unused for a long time, users are required to:
a. Disconnect the power source;
b. Empty the oil tank;
c. Lubricate the moving parts with hydraulic oil.
1.4
Training
Only these qualified people, who have been properly trained, can operate the hoist.
