40
Module Location
Module location is identified by a three digit
number which is labeled on the access side
of the base rail. The last two digits in the
location number are an incremental number
for the position.
The numbering begins at the return air side
of the unit. Module 101 will always be the
bottom module at the return air end of the
unit.
The unit tag number will also be displayed
on each module, so that each module can be
reattached to the correct unit.
Figure 5 - Module Location Example
Module Assembly
The following tools are suggested for
equipment assembly:
• Power drill with 5/16” socket
• Come-along (2)
• ½” wrench and socket
• Crowbar
• Phillips-head screwdriver
1. Move the section chosen to be installed
first, to the correct position. It is
recommended to start with the heaviest
section. If that is not possible then the first
section may need to be secured to prevent it
from moving when additional sections of the
unit are installed.
Summary of Contents for M3 Series
Page 53: ...53 Figure 28 Example Blow Through AAONEcat32 Rating Sheet ...
Page 73: ...73 ...
Page 74: ...74 ...
Page 75: ...75 ...
