A&D AD-4408C, Instruction Manual

Page: 56 / 68

AD-4408C Weighing Indicator
Page 54
10.3. Initialization Mode
The initialization restores the contents of the battery backup RAM and EEPROM to the
default values.
The three types of initialization are available as shown below.
Initialization mode Display Description
RAM initialization
ini ra
Initializes the contents of the battery
backup RAM only.
As the zero and tare values are stored in
the battery backup RAM, they will be
restored to 0.
General functions
initialization
inifnc
Initializes the contents of the general
functions stored in the battery backup
RAM and EEPROM.
All data
initialization
iniall
Initializes all the contents in the battery
backup RAM and EEPROM.
The calibration-related data is also initialized.
So, calibration is required before using
the indicator again.
10.3.1. RAM initialization / General functions initialization
Step 1 While holding down the ENTER key, press the F key.
fnc is displayed to indicate that the indicator will enter the general function
mode.
To return to the weighing mode, press the ESC key.
Step 2 While holding down the ZERO key, press the ENTER key.
1 Chc is displayed to indicate that the indicator will enter the check mode.
Step 3 Press the
∧
or
∨
key to select the initialization mode ( ini ) and press the
ENTER key.
Step 4 Press the
∧
or
∨
key to select the item to be initialized and press the ENTER
key.
Step 5 All the status LEDs blink to prompt a confirmation. To initialize, hold down the
ENTER key for three seconds or more.
After initialization, the indicator is reset and all the display segments are ON.
And the indicator enters the weighing mode.
To exit from this mode without performing initialization, press the ESC key.