© Copyright 2020 A&A Manufacturing. All rights reserved.
Page 8
Rev. 20200108
2. A membrane has purposefully been molded over the top of the 0.75” inlet port. This must
remain intact to allow for pressure testing the feed line. Prior to the start-up, this membrane
must be drilled out with a minimum of a 3/8” drill bit. Care should be taken not to drill too
deep and damage the plumbing that has been glued into the bottom of the canister. (A drilling
tool is available for purchase that will automatically center the drill bit and provide a depth
stop for perfectly drilled holes.)
2. Install the 1” threaded male adaptor (Figure 7a) and fill the canister with water to gravity test
the tank and glue joints.
3. At start-up, the 1” PVC stand-pipe, inside the QuikDekClor canister, should be cut so that it
extends approximately one inch above the pool’s water level. Once trimmed to the appropriate
length, push the stand-pipe into the supplied female adapter at the bottom of the canister
(Figure 7b).
4. Now the diverter can be installed into the 0.75” inlet port, in the bottom center of the canister
(Figure 7c).
Figure 6
Figure 7
Water Line
1.00”
(25mm)
a
b
c
Drilling
Tool
Summary of Contents for QuikDekClor
Page 2: ...Blank Page...
