I
NSTRUCTION MANUAL
AAPRODUCTSINC
F
or Technical Support Call:1-888-806-3972 / 626-332-4245
I
NSTALLATION INSTRUCTION
A
SSEMBLING THE RACK:
1
）
Find the Left & Right Mounting Bases; insert them to the bottom of the Screen. Secure with M10*60 Bolt
（
Note: Do not
tighten the bolts and nuts
）
2
）
Put the assembly onto the bed-rail, adjust the mounting bases to set the desired position for installation. Tighten the
M10*60 Bolts from the bottom slots.
M
OUNTING INSTALLATIONS:
HX501 provides flexible installations based on different pick-up trucks varied by Make & Models, customers can
freely choose one of the followings depends on the bed-rail structures, feel free to consult us if you need any
assistances.
1.
Direct Bolt-on Installation
: (Proper uses of Tools are required for installation)
1
）
According to the pre-drilled holes from the Mounting Bases, mark the drilling spot on the bed-rail. (Remove the
plastic bed-rail cover/cap if needed) Use a Drill to drill holes for the M10*45 Bolt. (Repeat those steps for the other side)
2
）
Tighten the Nuts to secure the rack. Installation completed.
2.
C-Clamp Mounting Installation
: (The C-Clamps installation might be limited due to different bed-rail structures varied
from different Make & Models, cutting of bed-liners might be required for C-clamp Mounting installation)
Set position for the mounting points. Ideally, set both mounting points apart for each C-clamps, for the purpose of
applying the mounting forces evenly onto the Mounting Bases. Set the inner (bigger) piece underneath the bed-rail, put
the outer (smaller) piece onto the Mounting Base and screw the bolts on. Tighten the bolt to complete installation.
3.
Stake Pocket Mounting Installation:
(Only work for pick-up trucks come with Stake Pockets on the bed-rail, this
option might not be available for certain Make & Models even if it comes with stake pockets on the bed-rail)
1
）
Take out the caps from the stake pockets. Put the pre-assembled rack onto the bedrail, determine if the slot hole
aligned with the stake pockets. (The slot-hole has to be directly on top of the stake pocket, if not, please consider other
installation options)
2
）
Take off the rack, be very careful. Take the Hoisting Shackle Assembly through the foam pad to forming a Kit, drop
the Kit inside the stake pocket. Pull the bolt to make sure the middle piece is hooking securely from inside.
3
）
This step needs extra attention. Keep pulling the bolt (may consider use tools like a small plier), slowly screw the
top piece to tighten the Shackle Assembly onto the stake pocket.
4
）
Put the rack back, apply the Flange Nut & Spring Washer & Washer(M12) and tighten to complete installation.
