Maintenance
9
Fuse Change
• Use a 2A Amp fuse.
• Make sure the unit is off and unplugged.
• Remove screws from the back of the unit.
• The fuse is located under a small, black plastic piece on the green ozone board & DC board.
• Apply some pressure to open the fuse holder.
• Remove the fuse.
• It may be necessary to pull slightly.
• Place the new fuse where the old one was.
• Press down until you hear it click into place.
• Close the compartment where the fuse is stored.
• When you hear it click, you will know it is secured.
• Close the back of the unit and put the screws back in place.
• The fuse has now been successfully changed.
Note: If the top (green) board LED is not on, this board fuse is bad. If the top (green) board LED
is on, but it does not produce ozone, the ozone board fuse is bad. If these errors occur, the ozone
LED on the panel will be red.
Summary of Contents for Aqua-8
Page 5: ...4 9 1 7 10 2 3 4 5 6 8...