5.
Locate the A3 IMU. Plug in the A3 Pro API Port Cable to the A3 Pro API port. It is important to make sure the
plugs are inserted properly. Follow the diagram below to ensure proper installation of the plug.
A3 Main Controller
CAN
2
API
SBus
F
1-
F
8
From left to right, make sure to plug
in black, then gray, then white.
11
7.
Install the M600 Pro’s Gimbal Mounting Kit (not included with the RDS1). Install the gimbal as shown. For now,
leave the clamping screws slightly loose. There will be an 8mm gap between the mounting clamp and gimbal
mount clamps once everything is installed.
6.
Plug in the XT30 male to female cable into the 6S lipo port. (For older models shipped with XT30 splitters instead,
plug in the included XT30 splitter to 18V). Tuck-in any excess wiring up into the bottom cover of the M600 Pro.
XT30 Splitter Shown Here
8mm
UNPACKING AND HARDWARE INSTALLATION
Summary of Contents for RDS1
Page 1: ...RDS1 USER MANUAL ...
