3
PATENTED HEAT PUMP
HUB RADIATOR DHP
Model
s
:
3.0+3.0 - 7.8+3.0 - 7.8+7.8 - 7.8+7.8+3.0 7.8+7.8+7.8 - 7.8+7.8+7.8+7.8
Technical information
SECTION A - GENERAL INFORMATION
It contains all the news related to the description of the air-water heat pumps and their technical
characteristics.
SECTION B - TECHNICAL NEWS FOR THE INSTALLER
It gathers all the indications and the prescriptions that the installer must observe for the optimal
realization of the plant.
SECTION C - USER'S INSTRUCTIONS FOR USE AND MAINTENANCE
It is the section reserved for the user and contains all the information necessary for correct operation
and for periodic checks.
Important notes for consultation
-
Important notes for consultation
1 For the purposes of a correct and safe use of the appliance, the installer, the user and the maintenance
technician, for the respective competencies, are required to comply with the instructions in this manual.
2 The word ATTENTION is followed by information that, due to its importance, must be scrupulously
observed and failure to comply with it may cause damage to the appliance and / or prejudice it safe use.
3 The paragraphs highlighted in bold contain important information, warnings or advice recommends to
evaluate carefully.
4 The technical data, aesthetic characteristics, components and accessories shown in this manual are not
binding. The A2B Accorroni E.G. Srl reserves the right to make any changes at any time changes deemed
necessary for the improvement of your product.
References to laws, regulations or technical rules mentioned in this manual are to be understood as a mere
title information and to be considered valid at the time of printing thereof, shown on the last page. Entry into
force of new provisions or amendments to those in force will not constitute a reason for any obligation
towards third parties.
The A2B Accorroni E.G. Srl is responsible for the compliance of its product with laws, directives and
standards of construction, in force at the time of marketing. Knowledge and observance of
legislative provisions and rules concerning the design of the systems, the installation, the operation and the
maintenance are the exclusive responsibility, for the respective competences, of the designer, the installer
and User.
