Page 12 06/2021
Installation and Operating Instructions
UPS Edition One 6kVA, 10kVA
It is recommended to charge the batteries for 24 hours before use. Turn the input
disconnect switch to „ON“ after connection; the UPS will charge the batteries
automatically. You can also start using the UPS immediately without charging the
batteries first, but the backup period may be shorter.
3.4 Communication cable connection
USB/RS-232:
The RS-232 or USB cable included in the accessories can be used to connect the UPS to
the PC.
If an appropriate cable is connected, the software can exchange data with the UPS.
The software obtains detailed information from the UPS about the status of the power
supply. In the event of a supply emergency, the software ensures that all data is saved
and the units are shut down properly.
Communication port SNMP (Optional):
Optionally, the UPS can be equipped with an SNMP communication interface.
It integrates the UPS into a network and after assigning an individual IP address, the
UPS can be accessed from any location. This is particularly interesting for remote
administration and maintenance.
Parallel card (Optional)
Optionally, the UPS can also be equipped with a parallel card. It is an optional expansion
card and enables parallel operation of up to 4 UPS systems until the desired capacity or
autonomy duration is reached.
Extended Battery Pack (Optional)
To achieve a longer bridging time, several battery cabinets can be connected.
Only use a compatible battery cabinet and the corresponding connection cable.
The battery voltage should be around 240VDC after connection.