4
DMP801
English
IP address setting method selection
When the PIN2 is set to ON, the IP address of
DMP801
is set via the UNIT ID Switch Set on the rear panel, and
when the PIN2 is set to OFF, the IP address of DMP801
is set via the control software connector�
Resume to the Factory Default
1. All settings and configurations are restored to the
factory default by setting PIN 7 to
ON
�
Firmware Upgrade
1.
Connect your DMP801 to your PC, and the switch the
PIN 1 to
ON
�
2.
Follow the on-screen instruction to carry on the firmware
upgrade�
Enable/Disable Panel VR
1.
Panel VRs are enabled when PIN 6 is set to
ON
�
2.
Panel VRs are disabled when PIN 6 is set to
OFF
�
INSTALLATION AND SETUP
RACK MOUNTING
DMP801 is compatible with 19” audio equipment rack� Slide the DMP801 in to the rack and secure it with four Phillips
screws�