A.R.C. Laser C-Pro, User Manual, Page: 14 / 40

Manual
C-PRO
14
4.5 Connecting the Micromanipulator to the Laser
4.5.1 Connecting the articulated arm
1. Make sure the laser is off.
2. Unscrew the black dust cap from the articulated arm.
3. Inspect the thread of the articulated arm. It must be clean and undamaged.
4. Screw the articulated arm to the C-Pro with the thread adapter. Make sure the
articulated arm is in the correct position. (see figure 7-8). The articulated arm is taken
out of the holder by means of slight pressure of the two fingers, so that the
connecting joint between the two legs assumes the position as shown here.
When the arm is correctly aligned, the
green symbol is visible.
In case the articulated arm is in the wrong
position, a red warning symbol shows up.
Fig. 9: Wrong position of the
articulated arm Fig. 7-8: The correct way to open the articulated arm