12
See: “Membrane Installation and Replacement” on page 12.
As shown in figure;
A: Connect feedwater to the water inlet of the device.
B: Post carbon outlet must be connected to RO faucet.
C: Wastewater tube must be connected to outflow tube.
• Use 3/8”drainage tube.
• Stick the self-adhesive sponge seal in the
wastewater clamp to the hole of the clamp.
• Drill a 6 mm hole on the outflow tube.
• Tighten the clamp (side with the seal) in correct
relative position of the hole to prevent any possible
water leakage. Make the seal connection on the
outflow tube . Ensure that the tube connection will
not loose.
• Drainage connection –It must be connected in such
a way that the wastewaterflows out without any
flush or air swirl.
• Ensure that the wastewater tube is not connected
to the dishwasher waste or garbage disposal
outflow line because it can result in back-pressure
and so, overflow.
• After these steps, RO unit is ready to be installed.
MEMBRANE INSTALLATION
TUBE CONNECTION DIAGRAM
DRAINAGE (WASTE) TUBE INSTALLATION
A
C
B
RO
Faucet
Waste
Water
Water
Inlet
