11
MANUAL INSTALLATION AND ASSEMBLY
INSTALLATION STEPS
SINGLE FAUCET WATER INTAKE
DOUBLE FAUCET WATER INTAKE
1. Before the installation, turn off the valve of main feedwater line orthe inlet
valve.
2. After draining the remaining water in the pipes, install feedwater
connection adapter (3-way adapter) by fastening with teflonband
(Figure A- 2)
3. Install 3/8’’ metal ball valve on the feedwater connection adapter (3-way
adapter) by means of teflon band so as to turn on/off easily (Figure A –3).
4. Install 8 mm water inlet tube to the 3/8 “metal ball valve. Note that the ball
valve is closed.
5. Then, turn on the valve of main feedwater line or the inlet valve and check
whether there is any leakage.
1. In case of drilling countertop or sink, faucet for clean water must
beinstalled carefully in terms of usage and aesthetics. You can start to
drillcountertop or sink after leaving enough space for installation of seal,
nut and union at the bottom of countertop or sink. Otherwise, you may
drill the wrong place.
2. If you drill marble, granite ceramic, laminate or sheet metal sink, firstyou
should use 5 mm drilling bit and then 12 mm drilling bit, respectively. The
drill must be operated at low speed and without impact. If the counter is
covered with tile-coated cast concrete, it must be drilled with a diamond
bit. (Figure A- 4)
3. Outer length of the faucet is 7 cm. If the counter is thicker than 7 cm,
you’ll need to use fittings as many as required. Finally, place the faucet into
the hole, adjust its joints and tighten the nuts.
RO FAUCET INSTALLATION
FIGURE A-2
WATER INTAKE IN UNDER COUNTER
3-way adapter
3/8 Ball Valve
3-way adapter
Extension
3/8 Ball Valve
FIGURE A-3
FIGURE A-4
FIGURE A-5
3-way adapter
3-way adapter
Closed
3/8 Ball Valve
Open
NOTE: If youd o not want to drill the undercounters ink and washbasin,y ou cana lsoi nstalli tb y using as inglef aucet. Contacty our au-
The images in the manual may not be identical to each other.
