INSTALLATION OF FAUCET
Drill a hole of 20-30mm in diameter to begin the installation.
1. Base installation
1. Insert the power cord though the rubber pad
and gasket. The rubber washer and gasket are
designed to have protrusions that should align
well against each other and with the center hole.
2. Take out two M4 screws, and insert one screw
into the washer and gasket through the base
hole so that both can rotate flexibly.
3. Place the base above the table hole, ensure the
washers are in place and drive the second screw
into the table from the base hole.
4. When installing the water outlet, the base
should face the corner of the sink.
5. Tighten the two screws.
2. Installation of faucet body
1. Cut a water pipe of appropriate length. Insert one end into
the socket of the main body and the other end through the
base, beneath the countertop.
2. Connect with the water outlet of the water purifier.
3. Insert the main faucet body into the base.
3. Installation of goose neck faucet
1. Ensure the three O-rings of the gooseneck faucet are all in the
O-ring groove.
2. Immerse the end of the O-ring in water and insert it into the
spout of the main body to complete installation of the faucet.
Countertop
Screw
Base
Rubber
washer
Gasket
Power cord
Goose neck
faucet
Handle
Base
Facet body
