10
FACTS TO CONSIDER ABOUT THE LOCATION
Carefully choose a location for the new water heater. The
placement is a very important consideration for the safety of
the occupants in the building and for the most economical use
of the water heater.
Whether replacing an old water heater or putting the water
heater in a new location, the following critical points must be
observed. The water heater must be located:
•
On a level surface. Shim the channel type skid base as
necessary if levelling is required.
LOCATING THE NEW WATER HEATER
•
Near a floor drain. The heater should be located in an area
where leakage of the tank or connections will not result in
damage to the area adjacent to the heater or to lower floors
of the structure.
• Close to the point of major hot water usage and the power
supply.
• Hot water piping and branch circuit wiring should be as
short as possible.
• Insulate hot and cold water piping where heat loss and
condensation may be a problem.
• Heater construction permits installation, maintenance, and
service work to be performed through the front control panel.
•
Suggested clearances from adjacent surfaces are 12 inches
on top, 30 inches in front for access to the unit.
• The heater may be installed on or against combustible
surfaces. The left side and back may be placed flush against
adjacent surfaces.
• The temperature of the space in which the water heater is
installed must not go below 32°F or above 122°F.
Printed on 2/8/2018 9:05 AM CT
Summary of Contents for 52
Page 8: ...8 FEATURES AND COMPONENTS Figure 2 Electronic Control Modules Printed on 2 8 2018 9 05 AM CT...
Page 9: ...9 FEATURES AND COMPONENTS Figure 3 Surface Mount Control Models Printed on 2 8 2018 9 05 AM CT...
Page 52: ...52 Copyright 2017 All rights reserved www hotwater com Printed on 2 8 2018 9 05 AM CT...
