21
RS-232 & Telnet Commands
COMMAND CODES
FUNCTIONS
P1
Power on
P0
Power off
OxIy
Set Output (x=1~32) to Input (y=1~32)
ALLOUT x
Set all Outputs to Input (x=1~32)
ACTIVE
Report active I/O channels
INDETECT
Input channel detection indicator
OUTDETECT
Output channel detection indicator
PORTSTATUS
Reports all Output connection status
HDCPON x
Set Input port (x=1~32) HDCP to 'ON'
HDCPOFF x
Sets Input port (x=1~32) HDCP to 'OFF'
HDCPONALL
Sets all Input port's HDCP to 'ON'
HDCPOFFALL
Sets all Input port's HDCP to 'OFF'
HDCPSTATUS
Shows the HDCP status of all Outputs (0=Disabled, 1=Enable)
MUTEO x
Mutes video for Output (x=1~32)
UNMUTEO x
Unmutes video for Output (x=1~32)
MUTEI x
Mutes video for Input (x=1~32)
UNMUTEI x
Unmutes video for Input (x=1~32)
MUTEALL
Mutes all Outputs
UNMUTEALL
Unmutes all Outputs
MUTESTATUS
Shows the mute status of all Outputs
HPDL x
Pulls the Input (x=1~8) hot-plug-detect signal to ‘LOW’.
HPDH x
Pulls the Input (x=1~8) hot-plug-detect signal to ‘HIGH’
HPDLALL
Sets the hot-plug-detect of all Inputs to 'LOW'
HPDHALL
Sets the hot-plug-detect of all Inputs to 'HIGH'
HPDSTATUS
Reports the hot-plug-detect signal status of all Inputs
EDIDMODE x y
Sets the EDID mode of Inputs (x=1~32) to y (1~3)
*
See Page 22 for details.
EDIDMODEALL x
Sets the EDID mode of all Inputs to x (1~3)
EDIDPORT y x
(
NOTE
:
Positions of x and
y do not follow convention)
Sets the EDID mode of the assigned port Input (y=1~32) to Output (x=1~32)
EDIDPORTALL x
The EDID mode of all ports are assigned to the Outputs (x=1~32)
EDIDSTATUS
Reports the status of the EDID modes of all Inputs
IRMASKOUT x y z*
Disable/enable (z=0/1) IR transmission from the IR input on the specified HDBaseT
™
Output Module’s port
(y=1~32/all) to the currently routed HDBaseT
™
Transmitter (x=src) or Receiver (x=sink).
Example 1:
“IRMASKOUT src 10 0” disables IR transmissions from the HDBaseT
™
Output Module’s IR In
port #10 to the currently routed HDBaseT
™
Transmitter’s IR Out.
Example 2:
“IRMASKOUT sink 5 1” enables IR transmissions from the HDBaseT
™
Output Module’s IR In
port #5 to the currently routed HDBaseT
™
Receiver’s IR Out.
A
NEU
VIDEO
