Miracle SteaMer
9
P/N 1010455 Rev. D 03/12
A.J. Antunes & Co.
OperatiOn
Operating instructions
1. turn the power on and allow the unit to preheat
for approximately 20–30 minutes.
nOte: Do nOt push any button during warmup
time. the flashing green ready light indicates that
the unit is nOt warmed up. the green ready light
will become steady when the unit is warmed up.
2. Pull out the spatula or Drawer assembly and set
the product to be steamed onto the spatula.
3. Push the spatula or Drawer assembly fully into
the steamer.
4.
single shot:
Press and release the
Operate
button, then wait 20 seconds for the steam to
penetrate the product.
timed cycle:
Press the
start/stOp
button to
begin the steaming cycle. the display will count
down to zero and an audio signal will sound at
the end of the steaming cycle.
5. Remove steamed product.
UP
DOWN
PRGM
START/STOP
POWER
READY
figure 5. Operating controls
ready light
power
switch
Operate
button
message
Display
start/stop
button
programming
cYc (total cycle time)
refers to the total pro-
grammed steam time set for the product.
shO (shot interval time)
refers to the time set
between shots of steam during a complete cycle.
h2O setting (steam shot time)
refers to the water
volume consumed during each water pump activation.
the amount of steam produced by your Miracle
steamer depends on the amount of water sprayed onto
the steam generator.
flooding of the generator may occur if the H2O setting
is too high. to prevent flooding, the shot interval time
(sHO) can be increased to allow more time for genera-
tor heat recovery. adjustments should be made to both
values to determine the best settings for your cooking
needs.
to program the control, refer to figure 6 and follow the
procedure below:
1. turn the unit on. the unit displays the factory
programmed total cycle time in minutes and
seconds (figure 6, item a).
2. Press and release to change the control from
OPeRatiON to PROgRaM mode.
3. to change the total cycle time in minutes, press
▲ or ▼ to change the time (Figure 6, Item B).
4. Press and release
again, and press ▲ or
▼ to change the Total Cycle Time in seconds
(figure 6, item c).
5. to change the sHO factory settings, make sure
the control is in PROgRaM mode, then press
and hold both ▲ and ▼ simultaneously for 1-2
seconds and release. sHO will be displayed
(figure 6, item D).
6. Press and release
and then press ▲ or ▼ to
change the sHO in seconds (figure 6, item e).
7. Press and release
again and press ▲ or ▼ to
change the sHO in minutes (figure 6, item f).
warninG
To avoid injury, be careful when pulling the
spatula or Drawer out from unit. be sure to allow
steam to escape before putting hands or face over
the steamer.
