18
WLBCF310 INSTRUCTION MANUAL www.909.com
WLBCF310 INSTRUCTION MANUAL www.909.com
Fitting the Brushcutter / Line Trimmer Guard
Before using either the Brushcutter or Line Trimmer,
the Brushcutter Guard needs to be assembled.
1. Lay the unit down so that the fuel tank bracket (38) is resting on a secure
surface, or on the ground.
2. Place the brushcutter guard (17) on the
underside of the lower shaft (15) so that the
2 holes on the guard line up with the hole in
the lower shaft. (Fig. S)
3. Place the guard clamp on the top side of the
shaft lining up the 2 screw holes on the clamp
with the 2 screw holes on the brushcutter
guard (25). (Fig. T)
NOTE
: There is a small dimple on the underside of
the guard clamp which when lined up correctly
will engage with the hole in the lower shaft.
4. Once the dimple is located, insert the 2 screws;
one on each side of the guard clamp, and using
the supplied 5mm allen key (36) tighten in a
clockwise direction until secure. (Fig. U)
If proceeding to use as the brushcutter, the 3T
brushcutter blade (28) needs to be assembled.
Refer to the “Fitting the Brushcutter Blade
instructions” (on page 20).
If proceeding to use the line trimmer, the clip-on
line trimmer guard attachment (33) and spool and
line assembly (35) requires assembly. Refer to the
“Fitting the Clip-on Guard Attachment to the Line
Trimmer” on page 22/23 and “Fitting the Spool
and Line assembly on the Line Trimmer” on page 23/24
for these instructions.
S.
U.
T.