16
WLBCF310 INSTRUCTION MANUAL www.909.com
WLBCF310 INSTRUCTION MANUAL www.909.com
3. Re-fit the J handle clamp plate on top of the
J handle (12) and replace the screws through
the clamp plate and into the clamp. (Fig M)
Note:
ensure the long hex headed screw is fitted
in the same position as was disassembled. The
longest screw should be the lower screw towards
the lower shaft. Both screws should be equally
tightened firmly on the clamp plate.
4. To change the length of the J handle (12),
repeat steps 1 – 4 above but locate the J handle in either of the other
two holes.
5. The J handle can also be moved up and down the shaft over a very short
and limited distance. There are two holes in the main shaft of which one
must locate on the locating screw on the J handle clamp.
Adjusting the J Handle up and down the Upper Shaft
1. Loosen the two clamp screws 6 full turns on the
underside of the clamp where the clamp plate
secures the clamp to the upper shaft (11), using
the supplied 5mm allen key and the 10mm open
ended spanner (36). (Fig N)
2. Lift the clamp so the location screw disengages
from the hole in the upper shaft (11). Move the
clamp to the second hole ensuring the location
screw locates into the second hole. (Fig O)
M.
N.
O.
