WLBCF310 INSTRUCTION MANUAL www.909.com
23
WLBCF310 INSTRUCTION MANUAL www.909.com
WARNING:
There is a cut off knife (32) on the
clip-on line trimmer guard attachment (33).
Use gloves to fit the clip-on line trimmer
guard attachment (33) to avoid injury.
1. Lay the unit down so that the fuel tank bracket
(38) is on the ground or on a secure surface.
Lift the gearbox end of the lower shaft (15)
to gain access to the output spindle (20).
2. Line up the tabs on the clip-on line trimmer guard
attachment (33) with the large slots on the
brushcutter guard (17). There are 2 main release
clips; one on each end of the clip-on line trimmer
guard attachment (33). This needs to line up with
the large slots on the brushcutter guard (17). (Fig AI)
3. When all tabs are lined up in position, push the
tabs on the clip-on line trimmer guard
attachment (33) into the slots, and the release
clips into the large slots. You will hear clicks when
the release clips are secure. (Fig. AJ)
NOTE:
Before using the line trimmer, remove the
cut off blade protector. After using the line trimmer,
it is recommended to replace the blade protector.
Fitting the Spool and Line Assembly on the Line Trimmer
NOTE:
If the unit has been used as a brushcutter first, the brushcutter
blade will need to be removed before fitting the spool and line assembly.
Refer to “Changing/Removing the Brushcutter Blade” for instructions on
how to remove the blade on page 21.
NOTE:
Always ensure the engine is turned off before undertaking this assembly.
1. Lay the unit down so that the fuel tank bracket (38) is on the ground or
on a secure surface. Lift the gearbox end of the lower shaft (15) to gain
access to the spindle (20).
IMPORTANT:
Ensure the inner flange is mounted on the spindle of the
line trimmer.
The outer flange (29), the protector (27), the 3T brushcutter blade (28)
and the blade nut (26) are NOT required when the line trimmer spool
& line assembly (35) is being fitted.
AI.
AJ.
