4
•
Do not open body casing. There are no user-serviceable
parts inside.
•
Do not operate the appliance in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust.
•
To reduce the risk of damage to plugs and cords never
pull the cable to remove the plug from a socket outlet.
After use
•
When not in use, the appliance should be stored in a dry,
well ventilated place out of the reach of children.
•
When the appliance is stored or transported in a vehicle
it should be placed in the boot or restrained to prevent
movement following sudden changes in speed or
direction.
•
The appliance should be protected from direct sunlight,
heat and moisture.
Inspection and repairs
•
Before use, check the appliance for damaged or defective
parts. Check for breakage of parts, damage to switches
and any other conditions that may affect its operation.
•
Do not use the appliance if any part is damaged or
defective.
•
Have any damaged or defective parts repaired or
replaced by an authorised repair agent.
•
Never attempt to remove or replace any parts other than
those specified in this manual.
Specific safety instructions for jump-starters
WARNING! To reduce the risk of injury and/or property
damage:
•
Follow these instructions and those published by
the battery manufacturer, vehicle manufacturer and
manufacturer of any equipment you intend to use with
this unit. Review warning labels on these products and on
the vehicle.
•
Explosive gas may be vented from the lead acid batteries
when charging and under extreme conditions battery
leakage may occur. Ensure the area is well ventilated
when conducting jump-starting and charging procedures.
•
The appliance must only be connected to a 12V lead-acid
battery. Do not use the appliance for charging dry-cell
batteries that are commonly used with home appliances.
These batteries may burst and cause injury to persons
and damage property.
•
Never allow the red and black clamps to touch each other
or another common metal conductor. This can cause
dangerous sparks, power arcing, and/or explosion.
•
Check the polarity of the vehicle battery terminals before
connecting the appliance. Always disconnect the negative
(black) jumper cable first: followed by the positive (red)
jumper cable.
•
The jump-starter power button should be in the off
position before connection to a power source or load,
when the unit is charging and when not in use.
•
When using this unit in proximity to the vehicle’s battery
and engine, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body parts
away from moving parts of the vehicle.
•
Replace worn or defective parts immediately.
•
After use, press the jump-starter power button and the
unit on/off button to turn the jump-starter off.
CAUTION! To reduce the risk of property damage:
•
Vehicles may have electrical and electronic systems (e.g.
engine management system, on-board computerized
system, mobile phone) that may be damaged if
subjected to high starting voltages and voltage peaks.
Before connecting the appliance to the vehicle read the
vehicle’s owner’s manual to confirm that external-starting
assistance is advised.