4B Watchdog Super Elite, Operation Manual, Page: 29 / 76

10.7 HEAD ALIGN INFO (2 OF 9) -
The head align info screen shows the head alignment sensor type and the current values for the sensor.
The sensor type can be off, pulsed, contact (CNT) or rub block (RUB). The display will vary depending
upon the sensor type (Image 8 A-C). Refer to section 14.6 for more information about head alignment
settings.
2 of 9: Head Align Info
CNT
ON
ON
OFF
Previous Next Exit
Type:
Current State Left:
Current State Right:
Alarm State:
2 of 9: Head Align Info
Previous Next Exit
Type: RUB
Sensor Value Abs Rel Trip
T#11 35 140 30 AMB1
T#12 69 140 30 AMB1
2 of 9: Head Align Info
PULSED
0
66
0
0
Previous Next Exit
Type:
Current Value [%]:
Alarm Value [%]:
Left Pulse Rate [PPM]:
Right Pulse Rate [PPM]:
Image 8A
Head Align Info - Pulsed Sensor
Image 8B
Head Align Info - Contact Sensor
Image 8C
Head Align Info - Rub Block Sensor
10.8 TAIL ALIGN INFO (3 OF 9) -
The tail align info screen shows the tail alignment sensor type and the current values for the sensor.
The sensor type can be off, pulsed, contact (CNT) or rub block (RUB). The display will vary depending
upon the sensor type (Image 9 A-C). Refer to section 14.7 for more information about tail alignment
settings.
3 of 9: Tail Align Info
CNT
ON
ON
OFF
Previous Next Exit
Type:
Current State Left:
Current State Right:
Alarm State:
3 of 9: Tail Align Info
Previous Next Exit
Type: RUB
Sensor Value Abs Rel Trip
T#11 35 140 30 AMB1
T#12 69 140 30 AMB1
3 of 9: Tail Align Info
PULSED
0
66
0
0
Previous Next Exit
Type:
Current Value [%]:
Alarm Value [%]:
Left Pulse Rate [PPM]:
Right Pulse Rate [PPM]:
Image 9A
Tail Align Info - Pulsed Sensor
Image 9B
Tail Align Info - Contact Sensor
Image 9C
Tail Align Info - Rub Block Sensor
PAGE 29
NOTE
To calibrate speed and utilize the Watchdog’s built-in alarm and shutdown capabilities, a motor
interlock (run signal) is required. For typical motor interlock wiring examples, review the wiring
diagrams for terminals 6 & 7.