– 28 –
– 29 –
ENG
Lithium ion batteries have many advantages over other batteries, mainly
due to their flexibility. They don’t have to be completely charged every
time they are used, nor do they have to be used continuously or fully
drained each time.
BATEC MOBILITY only uses batteries with the safest technology availa-ble,
including the BMS smart battery management system.
4.9.1 BASIC BATTERY USE
Inserting and removing the HANDBIKE BATEC ELECTRIC battery
You don’t need to touch any connectors to insert or remove the battery
from your HANDBIKE BATEC ELECTRIC, as this is done automatically.
(See fig. 38)
•
To remove the battery: Turn the key to the REMOVE BATTERY position
(OPEN). Grab the handle of the battery and pull up gently until the bat-tery
comes fully of the guide.
(See fig. 39)
•
To insert: Grab the battery by the handle. Set the lower right corner of the
battery in the side support tab until it clicks into the guide. Slide the
battery down slowly until it is resting completely in the mount.
(See fig.
40)
IMPORTANT!
If you leave the battery in the OFF AND REMOVE KEY WITH DETACH-ING
LOCK position (OFF), you won’t be able to remove it.
Connecting the battery:
To connect the HANDBIKE BATEC ELECTRIC battery, simply turn the key to the
ON position and use your HANDBIKE BATEC ELECTRIC normally.
(See fig. 41)
The battery charging system is protected by the smart battery man-
agement system (BMS), which cuts power if there is a surge or if any of the
battery cells are too discharged.
(See fig. 42)
CAREFUL!
Never, under any circumstances, use the discharging port on the bat-tery to
charge it or power it in any way, whether with an external pow-er source or
regenerative brake system.
Charging the battery:
•
The HANDBIKE BATEC ELECTRIC battery is charged with the 3-pin XLR
port on the side of the battery.
(See fig. 43)
•
Only charge the battery with the original BATEC MOBILITY charger
provided with your HANDBIKE BATEC ELECTRIC.
CAREFUL!
Never, under any circumstances, use chargers from other manufac-turers or
a charger from another HANDBIKE BATEC ELECTRIC, as the specifications for
each HANDBIKE BATEC ELECTRIC series are different.
•
Recharge time for the BATEC MOBILITY battery is 3 hours. Both the
charger and the battery management system cut the power when the
battery is fully charged.
•
Charging the battery: To charge the battery, the key must be in the OFF
or OPEN position. You can charge the battery whether or not it is
attached to the HANDBIKE BATEC ELECTRIC. Turn the cover of the
charging port, plug the charger first into the port and then into a
socket, then turn the charger on.
Summary of Contents for BATEC ELECTRIC 2
Page 27: ...52 FIG FIGURES...
Page 32: ...14a 16a 14b 16b 15 17 FIG...
Page 39: ...44 46 48 50 49 45 47 FIG...
Page 41: ...59 7 1 2 3 4 5 6 NUM 7 100 6 90 5 80 4 60 3 40 2 20 1 8 1...