Hardware and Installation Manual
|
VISIX V-Series All-in-One Cameras
–
Gen I
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
16
1).
Sensor (DI) connection:
Sensor (DI) can be connected to either a voltage type sensor or a relay type
sensor as the following figures. Settings can be done through the camera
’
s webpage.
Input voltage range:
0VDC minimum to 5VDC maximum, Max 50mA.
CAUTION:
Do not exceed the maximum input voltage or relay rate.
2).
Alarm (DO) Connection:
Only the relay type is supported.
Relay Rating:
Max 24VDC 50mA
CAUTION:
Do not exceed the maximum relay rating.
3).
LAN Connection:
This is a RJ45 LAN connector for 10/100 Base-T Ethernet. Use the Ethernet cable
(RJ45. to connect the device to a hub or a router in the network. Refer to
Section 6:
Power over
Ethernet Specifications
to for further detail.
4).
Power Connection:
The camera can be powered from either 12VDC or PoE. If the camera is
powered via PoE, refer to
Section 6:
Power over Ethernet Specifications
for further detail.
+3.3V
DI
COM
DI
COM
+
-
Relay Type
Voltage Type
+
-
Output of
Sensor
Output of
Sensor
Internal
Internal
+
-
DO
COM
Relay Type
Device
Internal
