Hardware and Installation Manual
|
VISIX V-Series All-in-One Cameras
–
Gen I
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
25
3.4.2
REATTACHMENT OF DOME COVER
–
ALIGNMENT
The screw hole where the cable line passes has a block next to it due to the cables
underneath. Thus, the part shaped differently from the other two screw hole parts
shall be aligned with the corresponding part of the dome cover, which is also shaped
differently from the other two parts.
Refer to the image on the right for the clarification.
CAUTION:
Do not forcefully pull or shake the dome cover as it is linked to the
camera body with a safety wire.
CAUTION:
To prevent products from damage, install the camera on stable and non-vibrating surfaces. If
the stability of a mount surface is in doubt, consult the safety personnel for reinforcements, and then
proceed with the installation.
3.4.3
ADJUSTING ANGLE OF THE CAMERA
Adjust the angle of the camera by manually moving the corresponding parts by reference to the directions
below.
CAUTION:
Refrain from continuous rotation of the camera gimbal or the inner liner to a single direction
as they are attached to the IR-LED cable inside.
CAUTION:
Be careful not to make the ambient light sensor hidden by the dome cover when adjusting
the camera angle. The ambient light sensor shall be uncovered for its normal operation.
NOTE:
Tighten the tilt stopper screw after the angle adjustment is completed.
A. To pan, rotate the gimbal
bracket horizontally.
C. For the horizontal rotation of
the lens, rotate the inner liner
clockwise or counter-clockwise
with the inner liner.
B. To tilt, tilt the camera gimbal by
vertically adjusting it.
Gimbal Bracket
Camera Gimbal
Gimbal Bracket
Tilt Stopper Screw
Inner Liner
Reset Button
