Installation Manual
|
VISIX Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
4
Cautions:
!
Make sure the power supply voltage is correct before using the camera.
!
Do not drop the camera or subject it to physical shock.
!
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol
and wipe it gently. If the camera will not be used for an extended period of time, put on the lens cap to
protect the sensor from dirt.
!
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The strong light can cause
fatal damage to the camera.
!
The sensor may be burned out by a laser beam, so when any laser equipment is being used, make sure
that the surface of the sensor not be exposed to the laser beam.
!
Do not place the camera in extremely hot, cold temperatures (the operating temperature should be
between -‐30°C ~ 60°C, or -‐40°C ~ 60°C if the camera model has an “H” in its suffix), dusty or damp
environment, and do not expose it to high electromagnetic radiation.
!
To avoid heat accumulation, good ventilation is required for a proper operating environment.
!
Keep the camera away from water and any liquid.
!
While shipping, the camera should be packed in its original packing.
!
Improper use or replacement of the battery may result in hazard of explosion. Please use the
manufacturer recommended battery type.
NOTE:
For cameras that support IR, you are required to pay attention to the following precautions to prevent IR
reflection:
!
Dust or grease on the dome cover will cause IR reflection. Please do not remove the dome cover film until
the installation is finished. If there is dust or grease on the dome cover, clean the dome cover with clean
soft cloth and isopropyl alcohol.
!
Make certain the installation location does not have reflective surfaces of objects too close to the camera.
The IR light from the camera may reflect back into the lens causing reflection.
!
The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate the
lens from the IR LEDS. Fasten the dome cover to camera body so that the foam ring and the dome cover
are attached seamlessly.
