3Ware 7000-2 - Escalade RAID Controller, User Manual

Page: 41 / 196

Hardware Installation
www.3ware.com 41
2 Install two jumpers on the converter if not already installed. See
Figure 7 for location to set jumper settings.
3 Connect a Power Converter Adapter to each converter. See
Figure 7 for connector locations.
4 When you have completed steps 2 and 3 for each converter,
install a Converter onto the back of each parallel ATA drive.
Make sure that each converter is properly aligned and securely
pushed in. The converter board’s power connector must be adja-
cent to the drive’s power connector. See Figure 7.
Note: The Serial ATA Converter has sharp points.
Please use caution when pushing the converter onto the
back of the drive.
5 Connect the Power Adapter to the power receptacle on the drive.
6 If your drives are not already installed in the computer chassis,
install them now. Be sure that the drives are connected to the
power supply.
7 Connect each power adapter to the power supply.
8 For each drive, select the end of an interface cable not connected
to the ATA RAID Controller and plug it into the Converter.