DIP ON Status
OFF Status
(remote offline alarm)
Note:
Only 1 fiber port + 1 copper
port Gigabit device supports
LFP.
disable LFP (remote
offline alarm)
2
Enable flow control
function
Disable flow control
function
3
Managed daughter
card:Device is in
remote mode. STA
indicator would blink
when device is in
remote mode.
Unmanaged daughter
card: reserved
Managed daughter
card:Device is in
local mode. STA
indicator is on when
device is in local
mode.
Unmanaged
daughter card:
reserved
4
Gigabit daughter card:
enable specified 100M
100M daughter card:
reserved
Gigabit daughter
card: disable
specified 100M
100M daughter card:
reserved
【
Console Port Connection
】
The device provides 1 channel procedure debugging port
based on RS-232 serial port. The interface adopts RJ45 port.
The pin definition as follows:
PIN
2
3
5.
PIN
definition
TXD
RXD
GND
【
Checking LED Indicator
】
The device provides LED indicators (this indicator includes
rack, management card and daughter card indicator) to
monitor the device working status with a comprehensive
simplified troubleshooting; the function of each LED is
described in the table as below:
Type
LED
Indicate Description
Rack
Indicator
P1/P2
ON
PWR is connected
normally
OFF
Power supply is
connected abnormally
or not connected.
Managem
ent card
Indicator
RUN
Blinking
The device is running
normally if the indicator
is blinking at a
frequency
ON/OFF The device is running
abnormally or is being
powered on
UP/DO
WN
ON
The port is normally
connected
Blinking
The port exists data
transmission
OFF
The port is
disconnected or running
abnormally
CONS
OLE
ON
The port is normally
connected
OFF
The port is
disconnected or running
abnormally
Daughter
card
Indicator
LINK
(GS1-
GS2/G
1-G2/
GF)
ON
Interface has
established valid
network connection
Blinking
Interface is in network
active status
OFF
Interface hasn’t
established valid
network connection
TP
OFF
Copper port is not
connected
Blinking
The copper port exists
data transmission
ON
Copper port connection
indicator
FX
OFF
Fiber port is not
connected
Blinking
The fiber port exists
data transmission
ON
Fiber port connection
STA
Blinking
The daughter card is
running normally and in
remote mode.
OFF
The daughter card is
not powered on/system
failure
ON
The daughter card is
running normally and in
local mode.
LFP
OFF
LFP function is not
enabled or port is
connected normally
ON
LFP function is enabled,
port is connected
abnormally
Note:
LFP function means that after LFP function is enabled
through the DIP switch, when any port of the daughter
card panel is disconnected, the LFP alarm indicator will
be on and the connection of another port will be forcibly
disconnected.
【
Logging in to WEB Interface
】
