CLI user manual
41
Switch(Ring)#
show ring
Ring III Enable
Group:1 ID: 1 port:1,2 type: Single Hello_time: 0*100ms state:Disable
Group:2 ID: 2 port:4,5 type: Single Hello_time: 0*100ms state:Disable
10.3 To enable or disable the ring
Users can use the following command to set the ring network enabled, 10.3.1 ring network to
set command:
Operating
Command
Description
Ring opening
Enable
{3|4}
3: Enable Ring3
4: Enable RSTP
Ring close
Disable
Switch(Ring)#
enable 4
[OK]
Tip: This configuration will be validated after restarting
Switch(Ring)# Disable Ring
[OK]
Tip: This configuration will be validated after restarting
10.4 The Ring3 configuration
Ring3 enabled, can use the following command to set the Ring3.
Table 10.4.1 Ring3 to set and modify:
Operating
Command
Description
Configuration
Ring3
Config ring3
{1|2} <id> <LoopType>
<port> <hellotime>
{1|2}
：
1 ring group 1, 2 ring group 2
<id>
：
Said
the
ring
network
identification, value of [0-255]
<LoopType>
：
0: Single
1: Couple
2: chain
3: Dual_homing
<portlist>
：
Ring network port
<hellotime>
：
value of [0-300]
