User Manual
10
Chapter 5 Network Configuration
5.1 Modify IP address
The switch default address is: 192.168.1.254, subnet mask is: 255.255.255.0. When entering into the
switch Web interface through internet explorer, the IP address of the switch and PC must be in the same
Local Area Network.
You can modify PC's or the switch's IP address to make sure that they are in the same Local Area
Network. Operating process can follow method 1 or method 2 as below,
Method 1: Modify PC's IP address
Click Start->Control panel->network connections->Local area Connection->Properties->Internet
protocol(TCP/IP)
Setting PC‘s IP address: 192.168.1.X (X is less than 254, from 2 to 253).
Click ―OK‖, IP address modifies successfully.
(Figure 5.1.1)
Method 2: Modify the switch's IP address through Blue_eyes manager software.
Install Blue_eyes manager software on the PC.
Enter into Blue_eyes management interface, click "Search" to search the device.
After searching the device, move mouse to the device, click right key, modify the device's IP
address,
Please make sure the device and PC in the same Local Area Network.
This configuration example does not use the Advanced button in the last picture. In one and the same network card
allows the use of multiple IP pseudo-address when use the advanced configuration of the IP address, at which
does not change the original address can still access the switch device. But in the IGMP polling and IEEE 802.1x
polling windows system cannot handle correctly, Unix-like system does not have this problem. The advanced users
have to pay attention to this issue.
Configuration preparing
