15
Please follow the steps below to complete the initialization:
1. Turn off the power.
2. Hold down the feed button and turn on the power. At this point, the power indicator color
will cycle as follows:
Indicator color cycle mode:
Purple
Blue
Red (blink 5 times)
Purple (blink 5 times)
Blue (blink 5 times)
Blue (fixed)
3. Release the feed button when the power indicator is blinking blue. At this point, the printer
will be reset, and then the power indicator will blink purple once, and finally the power
indicator will be blue in ready state.
After initialization, the printer configuration is restored to its default values as follows:
Parameters
Defaults
Speed
152.0 mm/sec (6 ips) (203DPI)
Density
8
Label width
4” (100 mm)
Label height
7.9” (180 mm)
Sensor type
Gap sensor
Gap setting
0.16” (4.0 mm)
Printing direction
0
Reference point
0,0 (upper left corner)
Offset
0
Tear-off mode
On
Peel-off mode
Off
Characters
850
Country code
001
Clear flash
No
IP address
DHCP
4.3.4
Skip the AUTO.BAS program
The TSPL2 command language allows the user to load an auto-execute file (AUTO.BAS) into
the flash memory. When the printer is turned on, it will be automatically executed according to
the file loaded by the user. When you want to skip the AUTO.BAS after power-on, you can use
this boot function to ignore this auto-execute file.